Today I’ll show you how to remove a ring that is stucked

今天我會告訴你怎麼將卡死的戒指

using dental floss and a safety pin.

用牙線及一支安全別針移出。

Take about 2 ½ feet of floss.

拿約76公分長的牙線

Line up the floss alongside of the ring.

將牙線整齊並列在戒指旁邊。

Using the safety pin, push the floss under and through the underside of the ring.

利用安全別針，將牙線推到戒指下方。

Be careful not to poke yourself.

小心別刺到自己。

Once you see the floss, pull the floss through

當你看到牙線穿過戒指下方時，將牙線拉出，

so that you’ll have about 6 inches on the wrist side and 2 feet on the finger side.

所以會有15公分長的線在手腕這邊及61公分長的線在手指那邊。

Hold the 6 inside under your thumb to keep in place.

留15公分在大拇指下以保持原位。

Wrap the first couple wraps close to the ring

纏繞的前幾圈要靠近戒指，

The more stuck the ring, the more wraps and the closer the wraps are together… the better

戒指纏得越緊，就要纏繞越多圈，而且要纏繞得比較近，這樣比較好。

Using a little bit of soap will also help.

也可用一點點肥皂來拿出戒指。

Wind the floss tight.

將牙線纏緊，

At the end of the floss create a loop and tuck the end under the loop to secure it.

在線尾打個圈，把線尾穿進圈中以固定。

Grab the 6 inch end and pull towards the finger tip

將15公分長的那端拉近指尖，

and slowly unwind the floss

並慢慢地拉開牙線環，

You will see the ring slowly locking down the finger

你就會看到戒指固定的地方慢慢往下，

and eventually slide off

最後就從指頭上滑出了。

Thank you for watching this urbanhow2do video.

謝謝收看urbanhow2do。