They were taking a look here at the high grade build divers, We rise, El Dora brute some Once again, this is just a variant of the previously released HD Death Army kits.

This is sort of basically actually Maur to the point, a variant of the death beast or the four legged version of The Death Army.

And so hopefully we'll get that original kid out sometime later on.

It's very likely I would say what it's going to be people in there or not.

We'll just have to wait and see.

But anyway, this new version is pretty interesting, definitely interesting.

Take on that.

I like the color scheme of it, although some people might find that maybe a little bit boring, just being so basically all gray.

But it's once again the case here in the builder's line that we're getting a kid that's just kind of fresh and unique and interesting.

We have, like the Earth three and the V to that whole thing is a little very unique.

The cell time also have very unique concepts with that bill and this one as well with the four legged thing.

While it's not totally original.

It's one of the very few times we've actually had this, an actual kit form.

We don't actually have the original kid that this is based off of out yet melt.

Really, While there are a few pros and cons, I would actually say this is probably a better kids overall than the original, just regular standard death Army kids, though, So we'll get into all of that and go through the accessories.

Everything here in this moment as always, guys, though just a big thank you to us again in store for their support.

If you guys want to check out the link to us, you know stories down below, you can check out everything there on the site and save 10% off everything.

Using the coupon code, There's aka Really is 10 to check that out.

That's where the accessories with the kids here, This is it.

This is the one only official accessory here for this give.

This is its main weapon.

That Tetra Dent does have a cool foil sticker in there.

I guess it's supposed to be for shooting beams out there, but as you can see, it's just this big giant four pronged acts here.

Basically, at the end of the day, it's just a couple of parts.

Doesn't really do anything else, is just that.

That's what it is.

And that is really all we have for the accessories.

Just pulled that in the hand.

And that's pretty much it that say, we do have some leftover parts from the original kit, namely the original rifle here, which was included with the original kid.

Of course, we have this and full of only three parts that you have all the parts for that and you also have the holding hand for that is, if you want to hold it as the actual spiked club form, you have the hand for holding that.

So that's a pretty useful accessory.

Yes, mother.

Just different leftover parts.

Like if you have the original spiked cuff part there for around the side of the form, if you prefer that you could use that instead, also, if you prefer the original head, you have just the original head part.

They're top of the head without the part.

They're at the front and obviously different spike there on the top minutes.

If you're building like a couple of these or something you wanted to build it into, like a team of them or something.

You want to have one.

It's like a commander and the other ones as non commander units he could use maybe like the original head or something like that you wanted to, and then the majority of the other left or parts are for making the legs.

Now the folded up legs here, which now make up the backpack for the original death Army K, are folded down to, you know, just ask the regular life so you could make most of the legs if you wanted to have this as just like a death army kid it just in this dark for color scheme in a little different parts there.

You can't make the legs in full, though.

You're missing a couple of parts to make the original feet from the death army, so you wouldn't be able to make it totally with this get unfortunately.

But since that's it for the accessories, let's just take a look at some of the articulation here.

While we're here now, desperate stickers that we have the one on the Tetra Dana, we have the ones here for the cannons above the shoulders of those air, Pretty well effective for being gigantic stickers on there.

Then basically, it's just these little purple ones here on the front of the chest for the eye, of course.

And then the two little purple ones on the top of the head there and there.

And just like with the original kit, if you remove the top of the head here and pop out this piece there for the mono if you turn that around the other side, you have a different version of the monolith granular size.

You can pick and choose between the two of those End whichever form you do ultimately choose ones.

You have the head back together.

You can also move the model light side to side a little bit.

Has this track aren't if you could just kind of push that little bit often side for having that looking off to the side like that.

So it looks pretty well.

And speaking of the fit on the top of the head, I do like the shape of the fin on the top of this pretty cool, interesting shape for that.

So Ultimately, the head will go up to about there, which is not too bad, actually pretty good on down to their also, like the new color piece, this very high color piece around the side.

It had also pretty cool.

Look for that in its sort of stomach section here.

This will move forward and back like that and then a little bit side aside a little bit as well.

You can also rotate a little bit there.

Also, see, you have some nice movement.

And the cool thing is that, like the backpack here or what is the folded up legs backpack?

As it were, it actually plugged into this part here, which holds all the legs together down below the waist, actually, so the whole top half of the body here moves freely without actually moving the backpack at all.

It's just stuck there.

You can move the whole upper body without having to adjust that as patrollers.

They still will move for him back like that.

They have the part in there which will swing to the fronts, not a polecat, but it works the same way as the typical kind of play kabaddi.

See for swinging shoulder joints.

You do still, unfortunately, have this seam line there on top of the shoulder part there.

And the shoulder parts here, which is just kind of changed from the original kid being just black circles or others like dark brown circles, are changed to Spike's.

Here on the shoulders with is a pretty fitting look for this kid.

So we got rid of the spikes on the forearm and we've got new spikes up here on their shoulders.

So it's pretty cool.

Look, I actually kind of interesting to mix and match put the spiked in spite on one kid and the inspite and inspite on the other kids.

Also, the thing to mention about the spikes here is that it's actually two pieces sandwiches.

You will have seen lines on each one of those spikes sticking out from the shoulders, which is pretty unfortunate.

And speaking of this piece here on the Forum that also does have a seam line on that as well.

This will move up and down.

You also have a new spike here on the back of off the elbow.

That's a new piece on their elbow will move as it did before just 90 degrees like that is not really all that great.

The wrist is just on a Baldwin, but actually does have a hinge in the wrist there as well for moving in and out like that.

And then upward movement of the arm is gonna be up to their about 90 degrees to the body.

So that is pretty limited.

And one more note on the seam lines on the forearm part the lighter, great part of the Forum.

There's also seem like on the inside and outside of that forearm there as well, going down here to the skirt sections.

These will move up and down like that on the side skirts move up and down like that on a separate the top and bottom half of this can actually just to show you this because you have the whole like it's the waist section of the original kid would like the pays for holding the legs.

Everything in the back skirt here is there as well, and that just basically is connected to this bar.

This is the lower half.

We have the four legs can't down there obviously and in the back pass connected on there with this part, which you could actually removed from that.

It's easy.

Just pull that part out of.

There is a part for holding on back back.

Just plugs down into there.

But as you can see, you'll just take the original hip section there, and it just lots done into this section for holding the four new legs before we take a look at the legs will just take a look back here at the backpack.

Now, as I said, it just kind of fixed into place.

You can actually move these a little bit forward and back like that.

They're not really gonna be all that much.

It's not really much to write home out there with those.

There's kind of to be stuck up there like that.

So for the legs, do you have one bend there at the top like that, which I guess would be sort of like we'll call that knee Bend one and then knee bend to down Here is another nice joint for much more full or bend like that so you can actually get a really full band with problems that's going to be running into the other like the problem I also have with ease that there's no rotation.

You can't rotate the legs at all so you can't turn anything at all like that, so you can't really adjust.

The pot's really all that much.

Unfortunately, I said, on the good side of the legs here, we only have one C minus on the inside of the lower leg.

There you have a seam line there, but otherwise that is it for those.

As for the ankles, each of these will move side to side like that.

You have full detail underneath and no hollow spaces there, so that's good as well.

He's will move forward and back a little bit like that.

So we will be able to do, I think, some posing with this.

But I think there's one or two more points of articulation, especially up around here at the hip section would have been nice, but it's just a very simple connection piece for these all to be plugged in there at the center.

So hopefully maybe if we were to ever get a master grade, a death army kid or something that it would actually have a point there at the connection, which will enable the like to swing side to side and then also a point for the leg to rotate here as well would be nice.

And for a quick side by side comparison.

Here it is with the original death Army kid.

And, as you can see, definitely Cem being noticeable differences in this game.

Maybe obviously with the old door, bro, we've got pretty much the full get there is still there with pretty minor changes around on the body of it.

But it still makes for a very different look.

Once it's all said and done, the one thing that I am already noticing, unfortunately with the posing of this is just holding onto the Tetra Dent.

There's a couple of problems.

The first problem is that the wrist of this kid is a little bit weak.

You have to make sure the risk is pushed in all the way firmly into the form so that you're getting a good, strong wrist connection there.

Otherwise, the weight of history is gonna wait that down.

It's gonna be kind of hard to hold hold up in any upward position there with the hand.

The other problem is that it's just a straight shaft.

There's no indentation or anything for where you're supposed to plug the hand onto that nuts.

It's a kind of a plus and minus thing.

Sometimes when you have weapons like that where there's specific points where you have to grab onto the handle of that very long staff, then I kind of find that limit limiting, like if you wanted to hold it on in somewhere else, that's not a specific point.

But that said, then you have another problem where, without that, it's just the straight shopped in the hand where it doesn't have any specific gripping point on that, so it can, like, unintentionally rotate or slide in there just if it starts to get loose Now, as is holding on to a relatively tightly.

But if you were gonna be changing the post with this a lot and just over time, I could see that could definitely get a little bit loose.

If your line's it it to maintain a strong grip on that, then it probably would be a good idea to just go ahead and glue that onto the hand or something like that.

If that's how you're gonna have a permanently post little more thing on a point before we wrap up the review.

If we go back here and just remove this part for the backpack, this does have the two pronged adapter point.

Therefore, it is kind of the standard backpack adapter it would take like this.

For example, the backpack parts from the recent relieved will release the Celts.

I'm gonna, for example, which you will be able to get us a separate set here in the very near future.

Good.

Attach those onto the back or something like that to give us some more weapons or a different look.

It'sjust example.

Of course, you could attach any number of different back backs onto there, so it's a pretty cool option.

If you wanted to get a couple of these may change of the backpack, use something else instead of just the pulled it up legs and the cannons there on its back instead, so I could make some pretty cool options.

So I will make one others just kind of small complaint about this.

And that is just if you want to do aerial posing with this just the way that his legs have designed again just going back to the lack of just a couple of one or two more points of articulation would have helped a lamp because you don't have those in there that just doing any sort of aerial post.

With this up on a stand, it's gonna You're gonna have a hard time getting the legs to look any sort of proper ways.

That just doesn't look kind of weird.

So it's definitely gonna be one of those kids that looks better keeping on the ground.

It's got four legs.

Just keep them on the ground.

That's probably gonna be for the best.

It's just kind of awkward to get the legs posed in the certain way.

That looks quite right, but I'm doing my best with it and still having a little trouble.