Name: 琴師每日小貼士--裂縫修補篇 (Luthier Tips du Jour - Crack Repair)
Uploaded: 2021-01-14T04:27:38.000Z
Duration: 3 min 24 s
Description: 【看影片學英語】數萬部 YouTube 影片，搭配英漢字典即點即查，輕鬆掌握單字發音與用法，長久累積看電影不必再看字幕。

I had a beautiful Brazilian rosewood guitar come into the shop

with a bunch of hairline cracks in the back.

This type of rosewood is famous for developing cracks,

especially if it is flatsawn and highly figured like the piece you see here.

It is possible that these cracks went undiscovered during the building process

and later began to show up in the way of cracks in the finish.

Let me show you how I do this type of repair.

I am going to use thin viscosity CA glue and a small pipette.

I use the pipette to apply a small amount of the CA to the crack.

Since it is thin viscosity it rolls right into the crack

filling the void in the finish as well as stabilizing the hairline crack in the wood.

Make sure to remove any dust or residue from the crack before applying the glue.

Also, do not use accelerator after applying the CA glue

as this has a tendency to make the glue turn white.

For any cracks in the wood that have not penetrated the finish

you need to apply pressure to them either from the outside or inside of the guitar

to separate the crack allowing the CA glue to penetrate.

Now that the cracks are repaired the next step is to repair the finish.

The finish on this guitar is catalyzed urethane and therefore it is necessary

to spray the entire back instead of just where the cracks are.

If it were an evaporative finish like lacquer or shellac

I could get away with just touching up the cracked areas.

I begin by using a small razor blade to scrape the CA glue level with the finish.

I then scuff sand the entire back with some sandpaper.

Once this is done I wipe naptha on the surface to see if there are any cracks visible

If you notice any cracks that have white residue in them

you can get creative with a marker to hide them.

I now mask off the entire guitar except for the back.

This way when spraying I only get the finish where I want it.

After some quality time spent in the spray booth

and then leveling and buffing the finish this is the end result.