Record, Play, Stop, Fast-forward and Rewind.

And above that, you can navigate to the Left and Right locators

in NUENDO.

You can navigate between the Events by going to the Previous and Next event.

And you can also use the Memory Zap function

and this helps you navigate between display areas of the Project.

If, say, we are zoomed in close in one area

and we want to memorize that position, we can hold the MEM button,

and then go to another place in the Project,

and then use the ZAP button to return back to the previously memorized location.

And then pressing ZAP again returns us to where we were.

This is really helpful when editing between different sections on a large Project.

Above that, we have other transport functions like Pre and Post Roll,

Punch In and Punch Out functions,

and the Cycle and Sync functions.

The Jogwheel is also a very powerful transport control.

It allows you to move the cursor freely throughout the Project

both very fast and very slow and precise.

In addition, you can use the Jogwheel to scrub through audio

or shuttle.

On the Touchscreen, many of the transport controls are duplicated

but there are additional ones such as the Left and Right locator position,

the Pre and Post Roll enables, and there are lengths,

the Snap function

and the Snap type.

You can adjust the Grid resolution,

change the Tempo

and enable the Click and adjust its level.

On the Marker tab, you have access to the Marker tracks on NUENDO and can locate quickly between them.

Then there is the ADR page that will be covered in another tutorial.

And finally, the Overview page

where you can actually zoom and locate throughout the entire Project using one finger on the Touchscreen.

The numeric pad can also be used to locate the Project cursor

simply by typing in a Timecode value.

When I do that, the Timecode value comes up on the screen.

When I enter,

the cursor locates.

If you switch to Marker mode and type in a Marker number,

the Marker will pop up on the Touchscreen, and then will locate to that marker.

If you would like to set a Marker,

simply press the SET button

at your current position and press Enter and that Marker will be created.

If you would like to set the position of the Left and Right locators, it works in the same fashion.

Press SET,

and hit the Left locator, and now that has been reset to the current position.

Set the right locator, SET and RIGHT.