Name: 項目：每個手機的無線充電器(PART 2) (Project: wireless charger for every phone (PART 2))
Uploaded: 2021-01-14T04:40:02.000Z
Duration: 4 min 14 s
Description: 【看影片學英語】數萬部 YouTube 影片，搭配英漢字典即點即查，輕鬆掌握單字發音與用法，長久累積看電影不必再看字幕。

Hi folks and welcome back to CreativitySlashDesign.TK

Today we show you the last episode to make our wireless charger for

Let's get started with the cutting plane for power and screw holes.

We put some tape to fix in place the plane,

therefore we proceed with a dremel to drill

Now, we take a full metal screw to practice

Then test the holes for the plastic screw that we have to use in this project.

after we apply a layer of thermal mixture

on back side, we put it in place and we proceed with soldering.

our old cutting plane and practice the hole for power's jack

Now, we make the holes for back screws and we solder the inside

power connection cable to the circuit on its output pins.

the new cutting plane for bottom side screws and for front side

with some hot glue. Just after that we connect the transmitter,

the correct connection and we fix it with some tape

Now we have to create the holes with the last part of plane

on front side of case, we taking the dremel for last time,

then we can close the case with all screws we've talked about. After some

checks, we cut this cavity inside the top-face of receiver's case

and put this presser to align the antenna of

transmitter with the one of receiver. You can use the cutting plane

in place. This is necessary because the heating receiver's antenna

curve the the top-face of transmitter's case and it prevent the correct

This is the final result for transmitter and receiver,

that you can make more less with the same tecnic descripted for

and you can terminate with some vinylic plastic paper

This run out our project, for all info please write your comment on

in YouTube's space, or in our blog's space.

Please subscribe you to youtube's channel or follow us