Name: TWB S1R安裝在雅馬哈R1 2015上。 (TWB S1R installation on Yamaha R1 2015)
Uploaded: 2021-01-14T07:06:14.000Z
Duration: 6 min 31 s
Description: 【看影片學英語】數萬部 YouTube 影片，搭配英漢字典即點即查，輕鬆掌握單字發音與用法，長久累積看電影不必再看字幕。

I'm Nick Kazakov and this is TWB S1R installation on Yamaha R1 2015

Stainless manifold with ports for O2 sensors and clamps

Titan clamp with rubber gasket for slip on

Remove EXUP cover to disconnect servo cables

Loosen slip on clamp and unscrew mounting bolt to remove slip on

Next, remove front covers from both sides to unscrew O2 sensors

Mark the O2 sensor to count turnovers up to complete removing

Next, loosen both clamps and remove mounting bolts from both sides and under the right foot peg

The catalyst is used to reduce harmful substances in exhaust gases

Servo motor is used to close exude to smooth engine power curve and for better work of catalyst

It should be mounted back, not to have error

Cover and seats are installed in reverse order

Tighten mounting bolt and clamps but not completely

O2 sensor should be twisted by 7 turns before installation to avoid wire tension

The slip on is fastened with clamp and springs

Now tighten clamps and mounting bolts сonsistently

Control the slip on position and correct if necessary

Reduce weight on 3.5kg
And has bass sound

TWB manifold allows to use O2 sensors, so closed-loop control remains

The volume can be reduced by installing DB killer

Subscribe, if information was interesting!

字幕列表影片播放

TWB S1R安裝在雅馬哈R1 2015上。 (TWB S1R installation on Yamaha R1 2015)

subscribe

completely

position

increase