Then we gently brush the glue in one direction, and make it a thin layer.

How many layer of glue should we put on the rubber ?

Usually one layer or two layers are enough, but actually it really depends on the player.

Please make sure you brush the glue in just one direction. If you start brushing in that direction, keep it the the same until you finish.

And again, keep brushing it in the same direction until you finish.

Then we wait and let it dry.

When the glue is dry, we can start gluing the rubber. Usually we start from the bottom of the racket.

When the position is correct, you can use the appropriate tool, just like this one, to roll over the rubber and make it firmly stick together.

Then we can use a cutter to cut the rubber, make sure the cutter is straight to the table surface.

Cut it using appropriate force. When you reach the edge and about to finish, use lesser force and cut it gently.