Placeholder Image

字幕列表 影片播放

  • Welcome to urbanhow2do!

    歡迎收看urbanhow2do!

  • Today I’ll show you how to remove a ring that is stucked

    今天我會告訴你怎麼將卡死的戒指

  • using dental floss and a safety pin.

    用牙線及一支安全別針移出。

  • Take about 2 ½ feet of floss.

    拿約76公分長的牙線

  • Line up the floss alongside of the ring.

    將牙線整齊並列在戒指旁邊。

  • Using the safety pin, push the floss under and through the underside of the ring.

    利用安全別針,將牙線推到戒指下方。

  • Be careful not to poke yourself.

    小心別刺到自己。

  • Once you see the floss, pull the floss through

    當你看到牙線穿過戒指下方時,將牙線拉出,

  • so that youll have about 6 inches on the wrist side and 2 feet on the finger side.

    所以會有15公分長的線在手腕這邊及61公分長的線在手指那邊。

  • Hold the 6 inside under your thumb to keep in place.

    留15公分在大拇指下以保持原位。

  • Wrap the first couple wraps close to the ring

    纏繞的前幾圈要靠近戒指,

  • The more stuck the ring, the more wraps and the closer the wraps are togetherthe better

    戒指纏得越緊,就要纏繞越多圈,而且要纏繞得比較近,這樣比較好。

  • Using a little bit of soap will also help.

    也可用一點點肥皂來拿出戒指。

  • Wind the floss tight.

    將牙線纏緊,

  • At the end of the floss create a loop and tuck the end under the loop to secure it.

    在線尾打個圈,把線尾穿進圈中以固定。

  • Grab the 6 inch end and pull towards the finger tip

    將15公分長的那端拉近指尖,

  • and slowly unwind the floss

    並慢慢地拉開牙線環,

  • You will see the ring slowly locking down the finger

    你就會看到戒指固定的地方慢慢往下,

  • and eventually slide off

    最後就從指頭上滑出了。

  • Thank you for watching this urbanhow2do video.

    謝謝收看urbanhow2do。

Welcome to urbanhow2do!

歡迎收看urbanhow2do!

字幕與單字

單字即點即查 點擊單字可以查詢單字解釋