Placeholder Image

字幕列表 影片播放

由 AI 自動生成
  • repair clinic encourages you to perform this procedure safely

    維修診所鼓勵您安全地進行此手術

  • in this video we will show one or more of these icons

    在這個視頻中,我們將展示一個或多個這些圖標。

  • to alert you went to use caution

    為了提醒你去小心

  • be sure you've unplugged the appliance before beginning

    在開始之前,請確認您已經拔掉了設備的插頭。

  • and turn off the hot and cold water supply valves

    並關閉冷熱水供應閥門。

  • you will also need to disconnect the two water supply hoses attached to the rear

    您還需要斷開連接到後部的兩根供水軟管。

  • panel

    面板

  • along with the drain hose

    連同排水管

  • be prepared for some water to spill out

    臨淵羨魚,不如退而結網

  • next you will need to remove the agitator

    接下來,你將需要移除攪拌器。

  • if your model has a rinse dispenser pull the lock ring up with your fingers

    如果您的型號有沖洗機,請用手指拉起鎖環。

  • and twist the dispenser upwards to remove next removed the agitator cap

    並將分配器向上扭動,取出下一個攪拌器蓋。

  • depending on your model you may also need to remove a dust cap

    根據您的型號,您可能還需要取下防塵蓋。

  • hold the agitator base and use a seven sixteenth inch socket to remove the bolt

    握住攪拌器基座,用十六分之七英寸的套筒取下螺栓。

  • and washer and pull the agitator upwards to remove

    和墊圈,並將攪拌器向上拉動,以去除。

  • now carefully tilt the appliance back so its rear panel rests on a towel or carpet

    現在小心翼翼地將設備向後傾斜,使其後面板放在毛巾或地毯上。

  • next unsnap the pump clips

    下一步,打開泵的夾子

  • and wiggle the pump off of the motor shaft

    並將泵從電機軸上搖動下來。

  • disconnect the motor wire harness

    拔掉電機線束

  • and unclip the wires from the plastic retainer

    並將電線從塑膠固定器上解開。

  • use a half-inch socket to remove the bolts attaching the gear case to the

    用半英寸的套筒卸下連接齒輪箱的螺栓。

  • base

    基礎

  • now carefully pull the motor and gear case assembly out

    現在小心翼翼地將電機和齒輪箱組件拉出來。

  • detach the old break cam by removing the c clip

    拆下C型夾,拆下舊的斷裂凸輪。

  • if still intact remove the old clutch band and lining by squeezing the spring

    如果仍完好無損,則擠壓彈簧,取出舊的離合器帶和襯片。

  • with pliers and lifting it out

    用鉗子把它夾出來

  • you're now ready to install the new band and lining kit

    您現在可以安裝新的帶子和襯裡套件了

  • place the new brake cam onto the drive tub and secure with the c clip

    將新的制動凸輪放到傳動管上,並用C型夾固定。

  • next place the two caps onto the band to hold the appropriate spring and spring

    然後將兩個蓋子放在帶子上,以固定適當的彈簧和彈簧。

  • dampener in place

    阻尼器到位

  • please note that if you have a compact washer you will need to install the

    請注意,如果你有一個緊湊型洗衣機,你將需要安裝

  • shorter spring and dampener in the clutch band otherwise use the longer

    離合器帶中較短的彈簧和阻尼器,否則使用較長的彈簧和阻尼器。

  • spring

    彈簧

  • use pliers to squeeze the spring to insert the new band and lining into the

    用鉗子捏住彈簧,將新的帶子和襯裡插入。

  • clutch housing

    離合座

  • now slide the motor and gear case assembly into position making sure the

    現在將馬達和齒輪箱組件推入位置,確保馬達和齒輪箱組件的位置是正確的。

  • clutch spring is opposite the break cam

    離合彈簧與凸輪相對

  • be aware this may require some adjustment before the gear case sits

    請注意,這可能需要一些調整,才能使齒輪箱安放好。

  • flush against the base

    貼地

  • secure with the bolts

    用螺栓固定

  • secure and reconnect the wire harness

    固定並重新連接線束

  • next align the motor shaft with the pump and slide the pump on

    然後將電機軸與泵對準,並將泵推上。

  • reinstall both pump clips

    重新安裝兩個泵夾

  • now carefully lift the appliance to its upright position

    現在小心翼翼地將設備抬起來,使之直立

  • place the agitator back onto the driveshaft and reinstall the bolt and

    將攪拌器放回傳動軸上,並重新安裝螺栓和。

  • washer

    洗滌器

  • replace the dust cap if your model has one

    如果您的型號有防塵蓋,請更換

  • replace the agitator cap

    更換攪拌器蓋

  • if your model has a rinse dispenser push it down until it snaps into place and

    如果您的型號有沖洗器,請將其向下推,直到它卡入到位,然後再將其推入。

  • press the lock ring down with your thumbs

    拇指壓住鎖環

  • reattach the water hoses

    重裝水龍帶

  • turn the hot and cold water valves back on

    開啟冷熱水閥

  • and plug the appliance back in

    並將設備的插頭插回

  • to make sure it's functioning properly

    以確保它的正常運作。

repair clinic encourages you to perform this procedure safely

維修診所鼓勵您安全地進行此手術

字幕與單字
由 AI 自動生成

單字即點即查 點擊單字可以查詢單字解釋